About Us
Modelcam Technologies provides a wide variety of Services from ART to PART from Concept Design to Industrial Modeling and Analysis for final Manufacturing.
An electric arc generates intense heat (ranging from 3,000°C to 5,000°C) to melt the metals.
Voltage too low, travel speed too fast, or improper torch placement.
Operators typically utilize a drag (pull) technique for FCAW. The general rule of thumb is "If there's slag, you must drag." Dragging keeps the slag behind the weld puddle, preventing slag inclusions. 5. Industrial Advantages and Limitations (Slide 13-14) Key Advantages
Travel speed too fast; voltage or amperage settings too low.
This is the technical heart of your PPT. Use a cross-section diagram.
A crucial segment of any FCAW presentation must distinguish between the two primary variations of the process.
Modelcam Technologies provides a wide variety of Services from ART to PART from Concept Design to Industrial Modeling and Analysis for final Manufacturing.
©Copyright 2026. All rights reserved by Modelcam Technologies Private Limited PUNE.
