Place the firmware file in the root directory of a USB stick. Insert the USB drive into the Touch module. Access .
Select and switch from DHCP to Static (recommended for infrastructure equipment). Input the assigned IP Address , Subnet Mask , and Gateway .
Navigating the menu tree is achieved by tapping items on the screen. To return to a previous menu, press the arrow key on the top left. To return to the main loop, tap the Home icon.
The ceiling voltage that triggers a critical alert and may disconnect rectifiers to protect the load.
Set the (safety timeout, e.g., 480 minutes) to prevent prolonged overcharging. Temperature Compensated Charging smartpack2 touch user manual
Many configuration menus are locked to prevent unauthorized changes.
Check physical battery temperatures. Verify the placement and wiring of the external temperature sensor.
Single rectifier failures, high ambient temperature, or minor mains deviations. Mapping Alarms to Physical I/O Relays
Three front-facing LEDs provide instant visual system status: Green (Power): System is operational and running normally. Place the firmware file in the root directory of a USB stick
: Configure IP addresses, SNMP settings, and email notifications for remote monitoring via the Ethernet port. 4. Safety & Maintenance
Advanced security protocols and support for SNMP (v2c/v3) and Modbus RTU for integration with Network Management Systems.
Features a web-based UI (CWUI) that allows for full configuration and monitoring via a standard web browser.
: You must connect the AC earth wire (PE) before connecting any AC input cables. Select and switch from DHCP to Static (recommended
"Come on, talk to me," Elias whispered. He navigated through the menu tree: Status > Inventory > Power Modules
Before you can manage your system, you need to establish communication with the controller, either directly through its interface or remotely via a network.
Displays charge/discharge current, temperature, and remaining capacity (State of Charge).