Icom Ic-v80 Programming Software Download [updated] Jun 2026

Extract your downloaded CS-V80 or CHIRP executable installation file. Run the setup wizard and follow the prompts to complete the installation on your local hard drive. Step 3: Connect and Power On the Radio Turn off the Icom IC-V80 completely.

A driver for the IC-V80 was officially added to CHIRP in , meaning your radio is fully supported. This is a powerful tool that allows you to:

If using a third-party cable, install the driver provided by the vendor (FTDI drivers usually install automatically via Windows Update, while Prolific drivers may require manual installation). Step 2: Plug in the Cable and Check COM Port Plug the USB end of the cable into your computer.

Interface is basic, and users must ensure they use the correct programming cable drivers to avoid connection errors. 3. Required Hardware for Programming

Insert the USB programming cable into an open USB port on your PC. Icom Ic-v80 Programming Software Download

Program hundreds of channels, including names (Alpha Tags), in minutes rather than hours.

However, for most users, CHIRP provides an excellent, cost-free way to program their radio.

You need a USB-to-Two-Pin programming cable compatible with Icom radios (specifically standard 3.5mm/2.5mm jacks).

Quickly write the same configuration to multiple IC-V80 units, ideal for clubs or emergency teams. Alternative: RT Systems WCS-V80 A driver for the IC-V80 was officially added

Software alone cannot program your radio. You must bridge the connection between your computer and the IC-V80 transceiver using specific hardware: The Programming Cable

Many users prefer for its more modern, user-friendly interface compared to the original Icom utility. Product: WCS-V80 Programming Software .

Before downloading the software, ensure you have the necessary hardware to connect your radio to your PC:

The Icom IC-V80 is a legendary, rugged VHF amateur radio prized for its durability, powerful 5.5-watt output, and crystal-clear audio. While you can program this handheld transceiver manually using the front keypad, entering dozens of frequencies, PL tones, and repeater offsets by hand is tedious and prone to errors. Interface is basic, and users must ensure they

“Time to program you the modern way,” Dave muttered, reaching for his laptop.

Set the standard VHF repeater offset (typically 0.600 MHz). Step 5: Upload the Data Back to the Radio Once editing is finished, go to the Radio menu. Click Upload To Radio . Verify the COM port is correct and click OK .

Modern, highly intuitive, and capable of importing data directly from RepeatersBook or RadioReference. Cost: 100% Free. 2. Step-by-Step: Icom IC-V80 Programming Software Download

He did it. The radio screen flashed .

Input dozens of channels in minutes rather than hours.