Toyota 4afe Ecu Pinout • Reliable & Safe

| Pin | Wire Color | Signal Name | Function | | :--- | :--- | :--- | :--- | | | Purple | TACH | Tachometer Output (from igniter via ECU) | | C02 | Yellow | NSW | Neutral Start Switch (Auto only) / Clutch switch (Manual) | | C03 | Red/Black | L | Oil Pressure Warning Light (some markets) | | C04 | Black | E2 | Ground for sensors (duplicate of B13) | | C05 | Pink | M-REL | Main EFI Relay Control (ECU turns relay ON) | | C06 | Green/Red | VTA2 | TPS Closed Throttle Position Switch (IDL) | | C07 | Green | VCC2 | Secondary 5V reference (rarely used) | | C08 | - | - | Empty | | C09 | Yellow/Blue | TC | Diagnostic Communication Line (OBD-I scanner) | | C10 | Black/Red | A/C IDL | A/C Idle-Up Signal (raises idle when A/C is on) | | C11 | Red | BATT | Constant 12V for ECU keep-alive memory | | C12 | Yellow/Green | STP | Stop Light Switch Signal (brake pedal input) |

| Pin # | Description | | --- | --- | | 1 | Battery Positive (B+) | | 2 | Ground ( chassis ) | | 3 | Ignition Switch Power (IG) | toyota 4afe ecu pinout

| Symptom | First Pin to Check | Expected Reading | |----------|--------------------|-------------------| | No start, no CEL with key ON | Pin A1 (B+) | 12V | | Fuel pump doesn’t prime | Pin A19 (FC) | 0V for 2 sec, then open | | CEL stays on, no codes | Pin A2 (Main relay) | 12V at relay coil | | Rough idle, surges | Pin A9 (PIM) | 3.5V at idle, steady | | No power above 4000 RPM | Pin A12 (IGt) | Clean square wave to 5V | | Check engine light won’t flash codes | Jump TE1 (A20) to E1 (A22) | Must be solid ground | | Pin | Wire Color | Signal Name

A 5V square-wave output signal sent from the ECU to the igniter, telling it exactly when to fire the ignition coil. You will not see 12V here with the key on

Pins B02-B05 (injectors) are switched grounds. The ECU grounds these wires to fire the injectors. You will not see 12V here with the key on. Instead, each wire should show continuity to ground for a brief pulse when cranking.