Simrad Rf300 Installation Manual Today

Re-verify the mechanical parallelogram geometry; an asymmetric linkage setup causes non-linear feedback. Preventive Maintenance

Your vessel's (hydraulic helm, linear mechanical drive, or rotary chain).

Verify that the internal components do not bottom out. The RF300 safely measures angles up to , but standard boat rudders only rotate between ±35 and ±45 degrees. 4. Electrical Wiring & Interface

The Simrad RF300 Rudder Feedback Unit (P/N 20193744) Go to product viewer dialog for this item. simrad rf300 installation manual

: If you need to extend the cable, use a twisted pair shielded cable to prevent electrical interference. JustAnswer 3. System Configuration & Calibration

If you must extend the cable, use 2-conductor shielded marine cable and heat-shrink butt connectors. Keep extensions under 30 additional meters. Interface Configuration and Calibration

on a stable platform so its center is aligned with the center of the rudder post. It can be mounted horizontally, vertically, or upside down. : Set the rudder to the center position. Rotate the The RF300 safely measures angles up to ,

Visually inspect the ball joints on the transmission link for wear.

Mount the RF300 upside down if necessary, but keep the shaft vertical.

Do not attempt to remove the transmitter arm from the RF300 unit. It is factory-adjusted, and disassembly can cause irreparable damage to the unit. : If you need to extend the cable,

Locate a flat, rigid structural surface near the rudder stock.

Once the mechanical installation and wiring are complete, you must calibrate the unit through your Simrad autopilot control head (e.g., AP11, AP16, AP20, AP24). Step 1: Set Rudder Zero

: Ensure the unit is not being bypassed by "Virtual Rudder Feedback" (VRF) settings. If your boat has a physical VRF must be OFF JustAnswer terminal diagrams for a particular Simrad junction box model? Simrad LIVE | Autopilot - Setup , Calibration and Features

What (e.g., AC10, AC20, J300X) are you pairing this with?

If you need to extend the 10-meter (33-foot) attached cable, use a high-quality, twisted-pair shielded marine cable.